Rex-Electrolux FI290/2TA+ Manuel d'utilisateur

user manualFridge-FreezerFI290/2TA+

Technical data Dimension of the recess Height 1580 mm Width 560 mm Depth 550 mmRising Time 20 hThe technical information are situated in

On the opposite side:1. Tighten the lower pin.2. Install the lower door.3. Tighten the middle hinge.4. Install the spacer.5. Install the upper door.6.

between the appliance and the kitchenfurniture is correct.Open the door. Put the lower hinge coverin position.44mm4mm3. Attach the appliance to the ni

7. If the appliance must connect laterally tothe kitchen furniture door:a) Loosen the screws of the part (G) andmove the part (G).b) Tighten the screw

12. Remove the brackets and mark a dis-tance of 8 mm from the outer edge of thedoor where the nail must be fitted (K).HaK8 mm13. Place the small squar

product is disposed of correctly, you will helpprevent potential negative consequences forthe environment and human health, whichcould otherwise be ca

212700641-00-15072009www.electrolux.com

Electrolux. Thinking of you.Share more of our thinking at www.electrolux.comContentsSafety information 2Operation 4First use 4Daily use 4H

• It is dangerous to alter the specifications ormodify this product in any way. Any dam-age to the cord may cause a short-circuit,fire and/or electric

Service• Any electrical work required to do the serv-icing of the appliance should be carried outby a qualified electrician or competent per-son.• Thi

partment let the appliance run at least 2hours on the higher settings.Important! In the event of accidentaldefrosting, for example due to a powerfailu

Helpful hints and tipsHints for energy saving• Do not open the door frequently or leave itopen longer than absolutely necessary.• If the ambient tempe

charging must therefore only be carriedout by authorized technicians.Periodic cleaningThe equipment has to be cleaned regularly:• clean the inside and

Periods of non-operationWhen the appliance is not in use for long pe-riods, take the following precautions:• disconnect the appliance from elec-tricit

Problem Possible cause SolutionThe temperature in theappliance is too high.The temperature regulator is notset correctly.Set a lower temperature. The